Z-D-I/O, 6-ch Digital Input and 2 Relay Output Modbus

Description:

The Seneca Z-D-IO is a ModBUS device with a 6 channel opto-isolated input and 2 relay Outputs. The Z-D-IO may be used as a pure I/O module controlled by a ModBUS supervised system or it can be used to control electric motors or for activating pneumatic and motorized valves.
Setup and configuration of the device is easily achieved using the Z-NET and Z-PROG software.

Specification:

• Inputs:
• 6 opto-isolated inputs for relay, PNP or NPN signals
• 3750 V Isolation Output to Logic
• 1500 Vac Isolation Input to Logic
• Transition: Level 10 Vdc and 3 mA ± 10%
• Minimum Pulse: 20 ms
• Output: 2 SPST, shared common
• Relay: 250 V, 5 A ac
• Jumper selectable NO (Normally Opened) or NC (Normally Closed)
• Modbus Communications
• Configuration and Setup Software IEC 61131
• Status Indicators Error, Power, RX & TX
• Communications Port: 
• RS485 - 2 Wire
• Speed (baud): 9600, 19.200, 38.400, 57.600,115.200
• Front Jack: 2400 Baud
• Response Time 400 mS 10-90 %
• Operating Temp 0 to 55 °C
• Humidity 30 to 90% at 40 °C non-cond.
• DIN Rail Mountable design 100 x 112 x 17.5 mm
• Detachable "plug in" screw terminal
• Power Supply:
• 10 to 40 Vdc
• 19 to 28 Vac
• 50/60 Hz

User configuration will require the S117P1 device (which can be purchased here) and the free EASY-SETUP software (which can be downloaded below).

Please refer to the following documentation for additional information: