Z-DAQ-PID, I/O universal module with PID regulation

Description:

The Z-DAQ-PID module acquires 1 universal input signal (voltage, current, potentiometer, thermo-couple, thermo-resistance, milli-voltmeter) and converts it to an analog format (with PID regulation), sent through 1 universal and isolated output signal (voltage, current).

General Characteristics:

• Three operating modalities: conversion with PID regulator, conversion without PID regulator, manual (constant output configurated through ModBUS register)
• Two output types: analog or ON/OFF (time of high-state digital signal is directly proportional to the analog signal)
• Possible inputs: voltage type, current type, potentiometer type, thermocouple (TC) type, RTD (Resistance Temperature Detector) type, millivoltmeter type
• Possible outputs: voltage type, active current type, passive current type
• Management of: slew-rate, burn-out, output limiters
• Configuration of the module (node) address and baudrate by Dip-Switches
• It’s possible to add/remove the module to/from RS485-bus without disconnecting the communication or power supply
• Switching automatically RS485 to RS232 or vice versa

Specification:

Order code :		Z-DAQ-PID
Description:		I/O universal module with PID regulation
Power supply:		10..40 Vdc; 19..28 Vac
Operating mode:		I/O conversion with PID, I/P conversion without PID, manual (fixedoutput)
Input:		Voltage, current, potentiometer, thermocouple (TC), thermoresistance (RTD), millivoltmeter
Output:		Voltage, active/passive current
Isolation:		1.500 Vac
Address & baud rate settings:		Dip-Switch
Automatic commutation:		RS485 - RS232