Z-PID, PID Analogue Controller ModBus

Please note this product has been superseded by the Z-DAQ-PID, however we do still have limited stock.

Description:

The Z-PID is designed to interface transducers and instruments with different analogue signals to a ModBUS RTU System with RS485.
The Z-PID also has an Analogue output and an integrated PID controller.
When the device is used in a temperature related application it's integratred PID controller can take into consideration the actual temperature and the desired temperature automatically adjusting it's output signal to ensure minimum under/overshoot.

Specification:

• Input:
• Thermocouple J, K, R, S, T, E, B and N
• Thermo-resistance Ni100 - PT100 3 / 4 wire
• Signal in ohm (potentiometer)
• Signal in current : up to 20 Ma
• Signal in voltage : up to 10 V
• Output 
• 4 to 20 mA or
• 0 to 20 mA
• Integrated PID controller
• Sampling time 300 ms
• Input protection up to 60 V (excluding mA input).
• 1500 Vac input insulation with respect to remaining low voltage circuits.
• RS485 serial communication with MODBUS – RTU protocol, maximum 32 nodes.
• Automatic setting of default values for regulator in the event of control system failure
• Communication times below 20 ms (at 38400 baud)
• Connection distance up to 1200 m
• Power Supply:
• 19 to 40 Vdc
• 19 to 28 Vac
• 50/60Hz

Associated Products:

Z-PC Line, Accessories and Software

Please refer to the following documentation for additional information: