Z-PC-DIN, BUS Connecting Power Distributor for Z-Liners

Description:

The Z-PC-DIN is a neat little device that plugs into the BUS connection available on the bottom of Z-PC-Lines, the Z-PC-DIN can then be clipped onto other Z-PC-DIN blocks and distribute the power emanating from a single Z-PC-Line wired to a power supply to a series of block and bus connected Z-PC-DIN's alternatively Z-PC-DIN's can be used with a Z-PC-DINAL which with it's direct power supply can replace the need to wire any Z-PC-Lines to a power supply.
Z-PC-DIN is available in several configurations with 2,4 or 8 way blocks, allowing power sharing between 2 to 8 Z-Line modules per blocks, blocks can also be connected to each other using "PIN Jumpers" (one Jumper is included per model).
The Z-PC-DIN's neat design also allows "hot swapping" (replacement of a single module whilst others on the same rail are still in use).

The Z-PC-DINAL is designed to be wired directly to a power supply and distributes power to the entire range of Z-PC modules part of the same Z-PC-DINAL or other BUS connected block.
The Z-PC-DINAL can also power RS485 communication lines saving even more wiring and time.
The Z-PC-DINAL is fully compatible and can distribute power to a Z-PC-DIN block, connection between the two (on a same DIN Rail...) is made using "PIN Jumper connectors".
The Z-PC-DINAL is particularly well suited for use with RS485 Z-Liners.
Please refer to the following documentation for additional information: